AutoTecknic Dry Carbon Fiber Cooling Shroud - Honda S2000

The S2000's forward-mid engine layout limits front overhang but creates heat management challenges under sustained hard use. The OEM cooling shroud handles normal driving conditions, but gaps in the seal become a factor on track or during extended high-load runs where intake temps climb. The AutoTecknic Dry Carbon Fiber Cooling Shroud seals those gaps -- directing airflow through the radiator and intake rather than around them.

Pre-preg construction: resin is impregnated into the fiber before the autoclave cure cycle. No pinholes, no resin voids. The result is a structurally consistent, visually clean part that is lighter than the OEM piece and heat-resistant at the temperatures this position sees. Fitment covers both AP1 and AP2 through the full 2000-2009 production run. Hardware included.

What You Get

• Cooling shroud
• Pre-preg dry carbon fiber, vacuum-autoclave cured
• Improves radiator and intake airflow seal under sustained hard driving
• Lightweight, pinhole-free construction
• Bolt-in OEM fitment, hardware included

Fitment

• Honda S2000 AP1 (2000-2005)
• Honda S2000 AP2 (2004-2009)

Installation Notes

Bolt-in replacement for the factory cooling shroud. AP1 and AP2 share fitment. Professional installation recommended to ensure correct seal and airflow alignment.