JLT Cold Air Intake (2011-2014 Mustang V6)
The JLT CAI for the 2011-14 V6 is a NO TUNE intake available in Black Textured Plastic.
INTAKE TUBE DESIGN
The JLT tube is roto molded ABS plastic to resist engine heat and keep the intake air charge nice and cool. NO METAL TUBING HERE!!
With no separate MAF housing or couplers air flow is fast and smooth.
Automatic cars need an additional fitting, which we provide. All you need to do is drill a ½” hole (we show you where) in the tube, install the supplied grommet, fitting and you’re done. Note, all kits sold to re-sellers will include the automatic fitting.
MOLDED IN MAF
It’s a full 84mm ID at the MAF area
The heat shield ABS plastic to block engine heat at idle and low speed.
It incorporates the fresh air inlet from the grill.
It uses a large area to make sure the filter has tons of cool air.
GAINS AND TESTING
10-15 RWHP has been seen with this intake!
Warning, If you see more “claimed” by others, ask them how. Also look over the dyno sheets real good for low number baseline runs or no dyno sheets at all. Many will base line the car with 87 fuel, then add 93 fuel and the CAI to show more power. We don't do that!
Standard finish is an OEM looking black textured plastic.
• JLT Intake Tube with Black Textured finish
• Silicone Reducer
• 3.5x8” S&B Powerstack air filter
• ABS Heat Shield
• Automatic fitting kit
• HD Clamps & all needed hardware
To properly clean your filter, we recommend the S&B Precision II Cleaning & Oiling Kit.
*TIP* by purchasing a 2nd air filter you can simply swap filters when it's time to clean it and not be rushed. Clean the first filter and it's ready when it's time to change again.
JLT Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals! For more information check the product page here JLT Air Filter PRE FILTER
This kit is street legal in all US states.
CARB Exempt ID: D-761-2